BOS specializes in electrical system upgrades.
This can include rewiring the entire system and installing pre-engineered
PLC systems. BOS can also replace relay logic with PLC controllers
to eliminate electrical failures. Each rebuild includes, as needed,
inspection and repair of all conduit, control buttons and legend
plates. BOS inspects your machine tool geometry using laser technology.
BOS also specializes in Turcite replacement on machine ways and
hand scraping to restore proper alignment. This can be done on-site.
In addition to rebuilding the mechanical components, we run detailed
inspections on the following systems...
On this Okuma rebuild, BOS
ground the column ways, replaced
the Turcite on the head ways, replaced
the lower axis roller ways, then hand
scraped the Turcite to bring the machine
to better than OEM specs.
On this partial rebuild, BOS reground
the saddle ways, replaced the Turcite
and hand scraped the saddle
to proper alignment.
Before work begins, BOS thoroughly reviews your
needs. A detailed cost estimate, with a list of work to be done,
is provided for your approval.
Our system of working with manufacturers eliminates
cost overruns and most problems before they occur. You can deal
with BOS with complete confidence.
[turning machines/milling machines/production
[machine shop capabilities/remanufactured
Copyright © 2003-2009 BOS Machine
Tool Services, Inc., Hillsdale, IL 61257. All rights reserved.
site is maintained by
J & R PC